Browse ventilators

Wi-Fi Interface

MAC-588IF-E

The award winning Wi-Fi Control Interface connects discreetly to your units control board and should only be installed by an authorised installer. The MAC-588IF-E Wi-Fi Interface is available with compatible Mitsubishi Electric High Wall, Floor Mounted, and Ducted Heat Pumps and Lossnay Ventilation Systems. Built-in as standard in many systems, the Wi-Fi interface can also be purchased as an optional upgrade at time of purchase, or retrofitted to an existing compatible Mitsubishi Electric model

$ POA

Please consult a specialist

Features
Downloads
Support

Features

Make Heat Recovery Ventilation Visible – with Optional^* Advanced Lossnay Wi-Fi Control

Elevating air quality and maximising energy efficiencies has never been easier, because now the power is in your hands.

See by how many degrees^† Lossnay is pre-warming or cooling your home in real time, helping you save on your power bill because less additional heating is required to get a room up to temperature.
And in summer, monitor by how many degrees Lossnay reduces the average temperature in your home, using Automatic Free Cooling^{^} Mode.
The App will also proactively remind you when it is time to clean your filters to maximise both cost efficient operation and health benefits.

Lossnay Wi-Fi Control truly is the smart evolution in fresh air ventilation.

Learn about Lossnay Wi-Fi Control

^*The following compatible Lossnay models can be connected to the Wi-Fi Control Service via a compatible Wi-Fi Interface MAC-588IF-E: VL-250/350/500 Vertical, LGH-RVX-E-1 and LGH-RVS-E Series only.

^†The outside ‘Fresh Air’ and the inside ‘Avg Temp’ air temperatures are measured by the built-in sensors that are centrally located in the main Lossnay Ventilation unit.

^{^}In comparison to using a dedicated cooling device. The unit will continue to use a small amount of power to bring colder fresh air from outside.